Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
4.3 Trimmer
GB
TC
Automatic closing time. Adjust the time that passes between the end of the opening manoeuvre
and the start of the automatic closing manoeuvre.
Note: with DIP1=ON, set TC>5s.
VM Adjustment of opening and closing speed.

4.4 Dip-Switches

Description
DIP1 Drive force.
DIP2 Electric lock function.
DIP3 Push&Go.
DIP4 Direction selection.
The opening direction is intended by
viewing the automation from the side
being examined.
4.5 Signals
LED
POWER ALARM
4.6 Doors requirements for handicapped persons use
If the SPRINT automation is used on doors for the passage of disabled persons, adjust the VM trimmer so that the opening and
closing times (excluding deceleration) are the same as, or greater than, those indicated in the table.
Door wing length
750 mm
850 mm
1000 mm
1200 mm
Make the adjustments indicated in the figure:
OPENING
SPRINT - IP1546
Normal. [25 Nm]
With the automation closed, there is a
permanent thrust current. The drive im-
pulse is given at the same time as the
start of the opening operation.
Disabled.
Left-hand opening.
ON
24 V= power supply.
50 kg
3,0 s
3,1 s
3,2 s
3,8 s
Description
OFF
Encoder / automation fault.
Door wing weight
60 kg
70 kg
3,1 s
3,2 s
3,1 s
3,2 s
3,4 s
3,7 s
4,2 s
4,5 s
16
MIN.
0 s
7 s/90°
ON
Low energy. [16 Nm]
Note: to use the automation in maximum
safety conditions (example: passage of
disabled persons):
- set TC>5s
- set MS=5s/90°
With the automation closed, before the
opening operation a closing thrust is
introduced at the same time as the drive
impulse.During the closing operation, the
speed increases slightly to ensure the
correct closing of the electric lock.
Enabled.
Right-hand opening.
Flashing
80 kg
3,3 s
3,4 s
4,0 s
4,8 s
MAX.
30 s
3 s/90°
90 kg
3,5 s
3,6 s
4,2 s
5,1 s
CLOSING

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sprintj

Table des Matières