DITEC SPRINT Manuel D'installation page 18

OPERATING INSTRUCTIONS FOR SPRINT SWING DOORS AUTOMATION
RELEASE OPERATION
In the event of maintenance, malfunctioning or emergency, if you
want to disconnect the automation, set the automation switch to
OFF and move the door manually.
If the door does not have an electric lock, use the appropriate
key to release it.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential
part of the product and must be supplied to the user. Read
them carefully as they contain important indications for the safe
installation, use and maintenance. These instruction must be
kept and forwarded to all possible future user of the system.
This product must be used only for that which it has been ex-
pressly designed. Any other use is to be considered improper
and therefore dangerous. The manufacturer cannot be held re-
sponsible for possible damage caused by improper, erroneous or
unreasonable use. Avoid operating in the proximity of the hinges
or moving mechanical parts. Do not enter the field of action of
the motorised door or gate while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger. Do not allow children to play or
stay within the field of action of the motorised door or gate. Keep
remote control or any other control devices out of the reach of
children, in order to avoid possible involuntary activation of the
motorised door or gate.
In case of break down or malfunctioning of the product, discon-
nect from mains, do not attempt to repair or intervene directly
and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the motori-
sed door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
OFF
Installer:
ON