DITEC SPRINT Manuel D'installation page 13

- Assemble the articulated arm, without tightening the tra-
vel screws [A], and fasten it to the automation, ensuring
it is inserted in the housing of the arm support.
- Fasten the bracket [B] to the door.
- With the door closed, adjust the arm and tighten the
screws [A].
3.3 Installation with sliding arm
Use the sliding arm for doors that open inwards (seen from
automation side).
- Remove the casing and fasten the automation on the
wall, respecting the measurements indicated in the figu-
re: refer to the hinge axis.
- Bore the guide [C] and fasten it to the door.
- Insert the sliding block [D] of the sliding arm in the guide
[C]. Fasten the arm to the automation, ensuring it is inser-
ted in the housing of the arm support.
- Insert the lid [E] and the two heads [F].
13
GB
SPRINT - IP1546