DITEC GLOBE IP1839 Manuel D'installation Et D'entretien page 24

OPERATING INSTRUCTION UP AND OVER AND SECTIONAL OVERHEAD DOOR AUTOMATION GLOBE
RELEASE INSTRUCTION
Perform the lock and release operations with the motor stopped.
Keep outside the range of action of the door. If released, the
door could move in an independent manner.
Note: to disconnect the door, interrupt the power supply and
disconnect the batteries (if fitted).
In case of an emergency, to open the up and over door manually,
perform the following operations:
- Internal cord release (fig. 1):
pull the cord with a downward movement until the lock release
lever is triggered. Keeping the cord pulled, open the door manually.
- ASB2 external cord release (fig. 2):
turn the release handle by 90° clockwise or anticlockwise
and open the door manually.
- ASB1 external cord release with key (fig. 3):
turn the key by 90° anticlockwise, remove the lock block and
pull the cord until the release lever trips and then move the
door slightly; fit the block in the lock and turn by 90° clockwise,
remove the key and open the door manually.
To restore motor operation, move the door manually: the release
mechanism fastens on automatically.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part of the
product and must be supplied to the user. Read them carefully
as they contain important indications for the safe installation, use
and maintenace. These instruction must be kept and forwarded
to all possible future user of the system. This product must be
used only for that which it has been expressely designed. Any
other use is to be considered improper and therefore dangerous.
The manufacturer cannot be held responsible for possible da-
mage caused by improper, erroneous or unresonable use. Avoid
operating in the proximity of the hinges or moving mechanical
parts. Do not enter the field of action of the motorised door or
gate while in motion. Do not obstruct the motion of the moto-
rised door or gate as this may cause a situation of danger. Do
not lean against or hang on to the barrier when it is moving. Do
not allow children to play or stay within the field of action of the
motorised door or gate. Keep remote control or any other control
devices out of the reach of children, in order to avoid possible
involuntary activation of the motorised door or gate. In case of
breack down or malfunctioning of the product, disconnect from
mains, do not attempt to repair or intervene directly and contact
only qualified personnel. Failure to comply with the above may
create a situation of danger. All cleaning, maintenance or repair
work must be carried out by qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the motori-
sed door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
Fig. 1
ON
OFF
Installer:
Fig. 2
Fig. 3