Instructions For Using The Motorcycle; Starting The Engine; Right Hand Handlebar Switch - SWM Superdual E4 2017 Guide Rapide

INSTRUCTIONS FOR USING THE MOTORCYCLE

STARTING THE ENGINE

While the engine is cold, i.e., after the motorcycle
has not been used for a while or in low ambient
temperatures, operate in the following manner:
1) Place ignition key (1) to ON position (the buzz that
you hear when you turn the key to ON is caused
by the fuel pump which puts the feeding system
under pressure);
2) pull the clutch lever (2);
3) position the gearbox pedal (3) in neutral;
4) Check that the button (4) is in the out position
and press it, followed by the start button (5).
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warm-
up and circulation.
NOTE
A safety switch is mounted on the clutch lever's
support, which ONLY allows the engine to be start-
ed with the clutch lever pulled.
With the stand lowered, the bike can only be start-
ed with the gear in neutral.
2
N
3
4
1
5

RIGHT HAND HANDLEBAR SWITCH

The right hand handlebar switch contains the fol-
lowing commands:
1) Engine start button
2) Emergency switch to shut off engine.
2
1
EN - 9