Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR USING THE MOTORCYCLE
STARTING THE ENGINE
While the engine is cold, i.e., after the motorcycle
has not been used for a while or in low ambient
temperatures, operate in the following manner:
1) Place ignition key (1) to ON position (the buzz that
you hear when you turn the key to ON is caused
by the fuel pump which puts the feeding system
under pressure);
2) pull the clutch lever (3);
3) pull the starter lever (2);
4) shift gear pedal (4) to neutral position then re-
lease the clutch control level;
5) Check that the button (5) is in the out position
and press it, followed by the start button (6).
Bring the starter lever (2) back to its original
position as soon as the motor can idle. When
starting with an already warmed up engine DO
NOT USE the starter. When a cold engine has just
been started, do not increase revs, to ensure an
adequate oil warm-up and circulation.
NOTE
A safety switch is set on the clutch lever support.
This switch allows you to ONLY start the engine
with the gearbox idle, or with the gear engaged
and the clutch lever pulled.
QUICK RS-SM_A000PP00695_ed1_06-2015.indd 9
2
N
4
5
1
6
RIGHT HAND HANDLEBAR SWITCH
The right hand handlebar switch contains the fol-
lowing commands:
1) Engine start button
2) Emergency switch to shut off engine.
3
2
1
EN - 9
14/07/15 16:39
Publicité
Chapitres
