Preliminary Controls - SWM Superdual E4 2017 Guide Rapide

PRELIMINARY CONTROLS

A. Engine-transmission oil level
Keeping the motorbike level and upright, check the
oil level through the inspection (1) window on the
right crankcase. Make sure the level is in between
the MIN and MAX notches.
To fill up, remove the filler cap (2).
1
2
EN - 6
B. Fuel level
Turn the ignition key to its "ON" position, check the
fuel level indicated on the gauge (1), and refuel if
necessary.
If the square (2) begins flashing, this indicates that
the reserve fuel level has been reached.
MAX
MIN
1
2
C. Coolant level
Check level (1) in right-hand radiator when engine is
cold (place the motorbike fully upright). The coolant
must be 10 mm above the elements.
The coolant must always be present in the expan-
sion tank (2); its level must be between the MIN and
MAX marks indicated in the figure.
The radiator cap (3) is provided with two locking
positions: the first one is for prior discharge of pres-
sure in the cooling system.
WARNING:
Avoid removing radiator cap when engine
is hot, as coolant may spout out and cause
scalding.
1