Fitting; Mechanical Components - Festo DGC Série Notice D'utilisation

DGC−...
7

Fitting

Fitting mechanical components
Leave all screws and threaded bolts in their original states, unless you are
S
requested to modify them in these instructions.
Avoid the band system becoming
S
damaged or excessively dirty.
Damage to the DGC−... will reduce its
reliability and service life.
Make sure that the drive is fitted free of
S
mechanical stress and distortion.
Replacing a linear drive type DGP(L)−... by a DGC−...:
Use the foot fastening adaptor type HPC−... .
Slide position above:
HPC−...−SO / HPC−...−S
DGP(L)−...
DGC−GF/KF
Tightening torques for the fastening screws
HPC−8
0.8 Nm
Fig. 10
Festo DGC−... 0604b English
Slide position behind:
HPC−...−SH / HPC−...−S
HPC−12/18 HPC−25
1.6 Nm 2 Nm
Fig. 8
Fig. 9
DGP(L)−...
DGC−GF/KF
HPC−32/40
4.5 Nm
31