Panasonic TY-ST55PE9 Mode D'emploi page 16

Assembly Procedure
4. Display Overturn-Prevention
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall prevention
accessories.
* The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or
falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will be
effective in all earthquake situations.
Fix the display both on the board and the wall.
■
To fix to the board
1) Fix the 2 overturn-prevention belts
the pedestal tube to the TV board with the 2 wood
screws .
● To assemble to the board, use the prepared holes.
● If there are no prepared holes, drill new holes to the
center of the base board width.
■
To fix to the wall
Use a commercially available, sturdy wire to secure it firmly to a wall or pillar.
● Pass the sturdy wire through the top hole of the pedestal tube.
● If the display is fixed to the pedestal tube
through the top hole of the pedestal tube,
pass the string or wire through the second
hole.
5. Removing the pedestal
Remove the display in an opposite way of "Assembly Procedure" after removing the power plug,
cables and overturn-prevention items.
● Please keep the removed items carefully for the time when assembling again.
16
(Cont'd)
attached to
Overturn-prevention belt Wood screw
Wire (commercially available)
Surface of wall