Ryobi RBV26B Manuel D'utilisation page 20

Deutsch (Übersetzung der originalen Anleitungen)
to follow these instructions can result in serious
personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
commercial solvents. Use clean cloths to remove dirt,
dust, lubricant, grease, etc.
WARNING:
Do not at any time let brake fl uids, petrol,
petroleum-based
lubricants, etc., come in con tact with plastic
parts. Chemicals can damage, weaken or
destroy plastic which may result in serious
personal injury.
You can often make adjustments and repairs described
here. For other repairs, have the blower/vacuum serviced
by an authorized service dealer.
CLEANING THE AIR FILTER
See Figure 12 - 13.
For proper performance and long life, keep the air fi lter
clean.
■ Remove the air filter cover by turning the dial counter
clockwise while gently pulling out the cover.
■ Rinse the filter with clean water.
■ Gently squeeze filter until excess water is removed.
Replace the filter.
■ Place the air filter cover back on the unit. Turn dial
clockwise until the cover is secured.
CLEANING THE EXHAUST PORT, SILENCER AND
SPARK ARRESTOR
Depending on the type of fuel used, the type and amount
of lubricant used, and/or your operating conditions, the
exhaust port, silencer, and/or spark arrestor screen may
become blocked with carbon deposits. If you notice a
power loss with your petrol powered tool, you may need to
remove these deposits to restore performance. We highly
recommend that only qualifi ed service technicians perform
this service.
It is recommended to clean or replace the spark arrestor
every 50 hours or yearly to ensure proper performance of
your product. Spark arrestors may be in different locations
depending on the model purchased. Please contact your
nearest service dealer.
WARNING:
To avoid a fi re hazard, never run the blower/
vacuum without the spark arrestor in place.
English (Original instructions)
products, penetrating
VACUUM BAG
A dirty bag will reduce performance. To clean the bag, turn
it inside out and shake. Wash the bag in soapy water at
least once a year.
THE FUEL CAP
WARNING:
A leaking fuel cap is a fi re hazard and must be
replaced immediately.
The fuel cap contains a non-serviceable fi lter and a
check valve. A clogged fuel fi lter will cause poor engine
performance. If performance improves when the fuel cap
is loosened, the check valve may be faulty or the fi lter is
clogged. Replace the fuel cap as required.
SPARK PLUG REPLACEMENT
This engine uses a Ryobi AC00160, Champion RCJ-6Y
or NGK BPMR7A spark plug with a .025 in. electrode gap.
Use an exact replacement and replace annually.
STORING THE PRODUCT
■ Clean all foreign material from the product. Store
idle unit indoors in a dry, well-ventilated area that is
inaccessible to children. Keep away from corrosive
agents such as garden chemicals and de-icing salts.
■ Comply with all the ISO and local regulations for the
safe storage and handling of petrol.
When storing for 1 month or longer:
■ Drain all fuel from the tank into a container approved
for petrol. Run the engine until it stops.
18 18