Electrical Connection; Disposal And Recycling - Scheppach DP60 Traduction Des Instructions D'origine

Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Carbon brushes, drill bit
* Not necessarily included in the scope of delivery!
12. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C.
Store the electric tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.

13. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Important information
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor
can be switched back on again.
Faulty power supply cables
Insulation damage often occurs at power supply ca-
bles.
Causes are:
• Pressure points when power supply cables are rout-
ed through the window or door gaps
• Bends due to improper fastening or guiding of the
power supply cables.
• Interfaces by running over the power supply cables.
• Insulation damage by pulling off the wall outlet.
• Cracks due to ageing of the insulation.
Such defective power supply cables must not be used
and are extremely dangerous to life because of the in-
sulation damage!
Check power supply cables regularly for damage.
Make sure that the power cable is not connected to the
mains supply when you check.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
If it is necessary to replace the power cable this should
be done by the manufacturer or their representative to
avoid safety hazards.
AC motor:
• The mains voltage must be 220 - 240 V~.
• Extension cables up to 25 m length must have a
cross section of 1.5 mm
• Connections and repairs of electrical equipment
may only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Motor data - type plate

14. Disposal and recycling

must be disposed of as special waste. Ask your dealer
or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product
must be disposed of at a designated collection point.
This can occur, for example, by handing it in at an au-
thorised collecting point for the recycling of waste elec-
trical and electronic equipment.
www.scheppach.com
.
2
The equipment is supplied in packaging to
prevent it from being damaged in transit.
The raw materials in this packaging can be
reused or recycled.
The equipment and its accessories are
made of various types of material, such as
metal and plastic. Defective components
GB | 31