Wiring Connection - Toshiba MMC-AP0151H Manuel D'installation

Wiring connection

• Be sure to pass the wire through the wire connection port of the indoor unit.
• Keep a margin (Approx. 100mm) on a wire to hang down the electric parts box at servicing, etc.
• The low-voltage circuit is provided for the remote controller.
• Loosen the cover mounting screws (2 positions) of the electric parts box, and then remove the cover.
• Slit the film of attached bush for the power and remote controller wire take-in port, before pass through wires.
• Connect the indoor/outdoor connecting wires and the remote controller wire to the terminal block of the electric
parts box.
• Tighten screws of the terminal block securely, and fix the wires with code clamp attached to the electric parts box.
(Do not apply tension to the connecting section of the terminal block.)
• Mount the cover of the electric parts box. Do not pinch the wires.
Power supply
terminal block
R(L) S(N)
Cord clamp
REQUIREMENT
Two screws
Electric parts box
Indoor/Outdoor inter-unit wire/
Remote controller terminal block
U U A B
1 2
Cord clamp
P.C. board
Earth line
Power supply cord
14
Terminal block
R S
(N)
(L)