Wiring Connection - Toshiba Carrier RAV-SP180KRT-UL Manuel D'installation

+001111052201_00Ta.book Page 18 Friday, November 20, 2009 11:45 AM
High-Wall Type

Wiring Connection

REQUIREMENT
• Be sure to connect the wires matching the
terminal numbers.
Incorrect connection causes a trouble.
• The low-voltage circuit is provided for the wired
remote controller.
(Do not connect the high-voltage circuit)
▼ When using the supplied wireless remote
controller
1. Remove the air inlet grille.
Open the air inlet grille upward and pull it
toward you.
2. Remove the front panel.
3. Remove the terminal cover.
Terminal block for
indoor/outdoor
connecting
Terminal Cover
Screw
4. Remove the conduit cover.
Screw Conduit hole
(dia. 7/8" (22.2 mm))
All manuals and user guides at all-guides.com
Ground
S
screw
L
2
L
1
Screw
Cord clamp
Conduit cover
– 18 –
5. Attach a conduit to the conduit cover with a
lock nut.
6. Take the Indoor/Outdoor connecting wire
(3 x AWG12) and the ground wire
(1 x AWG12) out of the cable slot on the
rear panel so that it protrudes about 11.0"
(280 mm) from the conduit cover.
Indoor/Outdoor
connecting wire
0.8" (20 mm)
S
11.0"
L
2
(280 mm)
L
1
Conduit
0.4" (10 mm)
cover
<Stripping length of the Indoor/Outdoor connecting wire>
7. Insert the Indoor/Outdoor connecting wire
(3 x AWG12 (polar)) fully into the terminal
block and secure it tightly with screws.
Tightening torque: 0.9 ft•lbs (1.2 N•m)
Secure the ground wire (1 x AWG12) with
the ground screw.
8. Clamp the Indoor/Outdoor connecting wire
and the ground wire with the cord clamp.
L L S
1 2
Installation Manual
Ground wire
Connecting wire
Terminal
block for
indoor/
outdoor
connecting
Ground
screw
Ground
wire
Cord clamp
Indoor/Outdoor
connecting wire
EN
18-EN
Toshiba