Toshiba MMC-AP0151H Manuel D'installation page 10

3
INSTALLATION OF INDOOR UNIT
Pipe knockout hole
* Cut off the groove section with a metal saw or plastic
cutter, etc.
• In case of taking pipe from the rear side
* Cut off the groove section with a plastic cutter, etc.
Ø100
Grooves
• In case of taking pipe from right side
• In case of taking pipe from left side
Taking pipe from left side is applied only to the
drain pipe. The refrigerant pipe cannot be taken
out from the left side.
Groove
• In case of taking pipe from upper side
Taking pipe from upper side is applied only to
the refrigerant pipe.
When taking out the drain pipe from the upper
side, use a drain up kit sold separately.
Open the upper pipe draw-out port (Knockout hole)
shown in the external view.
(Knockout hole of thin plate)
After piping, cut off the attached heat insulator of the
top plate to pipe shape, and seal the knockout hole.
Knockout hole of power cable take-in port
Open the power cable take-in port (Knockout hole)
shown in the external view and then mount the
attached bushing.
Rear cover
Opened when refrigerant pipe
is taken out from the rear side
Opened when only drain pipe
is taken out from the rear side
Groove
Side panel (Right side)
Side panel (Left side))
Installation of indoor unit
• Preparation before hanging-up the unit
* Confirm the ceiling material and construction
beforehand hanging the fixing method of hanging
up.
<There is ceiling material>
Indoor
unit
Nut
(Procured locally)
Indoor
unit
* Tighten the hanging metal with upper/lower nuts
as shown in the figure.
<There is no ceiling material>
Indoor
unit
• Hanging-up of the unit
1) Attach washer and nuts to the hanging bolt.
Ceiling surface
Washer
(Accessory)
7
Hanging bolt
(Procured locally)
Ceiling surface
Washer (Accessory)
Double nut
(Procured locally)
Hanging
metal
Hanging bolt
(Procured locally)
Ceiling surface
Washer (Accessory)
Double nut
(Procured locally)
Hanging
metal
Hanging bolt
(Procured locally)
Washer
(Procured locally)
Washer (Accessory)
Double nut
(Procured locally)
Double nut
(Procured locally)
Hanging bolt