External View - Toshiba MMC-AP0151H Manuel D'installation

3
INSTALLATION OF INDOOR UNIT

External view

Upper pipe draw-out port (Knockout hole)
Power supply wire take-in port (Knockout)
128
Remote controller wire take- in port
84 (Knockout hole)
Left drain size
B (Hanging position)
Refrigerant pipe (Gas side ØD)
Hanging bolt
Ceiling surface
indoor unit
Installation of hanging bolts
• Considering pipe/wire connecting work after the indoor unit has been hanged, select an installation place and
determine piping direction.
• After installation place of the indoor unit has been determined, install the hanging bolts.
• For the hanging bolt pitch, refer to the external view and the attached installation pattern.
Please procure the hanging bolts and nuts for
installation of the indoor unit at local site.
[How to use the attached installation pattern]
The installation pattern is attached inside of the package cap.
Use the pattern for positioning of the hanging bolt.
Indoor
unit
216
110
Refrigerant pipe
(Liquid side ØC)
75
A
50mm
or less
Ceiling board surface
210
167
76 105
Drain pipe connecting port
97
146
347
262
135
Pipe hole on wall
(Ø100 hole)
Outside air take-in port
(Duct sold separately)(Knockout hole Ø92)
• Wired remote controller (RBC-AMT21E)
Wireless receiver
mounting section
Hanging bolt
Nut
Installation
pattern
• As an error may generate a little on the size of the
installation pattern due to temperature or humidity,
be sure to confirm the size.
5
Pipe draw-out port (Knockout hole)
Drain port VP20
(Inner dia. Ø26, hose attached)
Model MMC- A
AP0151H, AP0181H
910
AP0241H, AP0271H
1180
AP0361H, AP0481H 1595
Remote controller wire take- in port
Power supply wire take-in port (Knockout hole)
Remote controller wire take- in port
(Knockout hole)
Drain pipe draw-out port
(Knockout hole)
4
120
M10 or W3/8
M10 or W3/8
B C D
855 Ø6.4 Ø12.7
1125
Ø9.5 Ø15.9
1540
84
16
4 pieces
8 pieces
Ceiling surface
Wall surface