Maintenance And Care; Inserting/Removing The Battery; Handpiece/Battery Care; Cleaning The Light Guide - 3M ESPE Elipar DeepCure-S Notice D'emploi

Error
The LED showing the
operating status in the
charger flashes alter-
nately red and green.
The handpiece is not
in the charger.
The LED showing the
operating status in the
charger flashes alter-
nately red and green.
The handpiece is in
the charger.
The LED showing the
operating status in the
charger does not come
on although the plug
has been connected to
an electrical outlet.
The light intensity is
too low.
The dental material
does not cure
completely.
The light guide cannot
be attached to the
handpiece.
8
Cause
Solution
Charger is defective.
Have the charger repaired.
Malfunction during charging.
The battery is damaged.
Replace the battery.
Power outlet carries no
voltage.
Use a different power
outlet.
Charger is defective.
Have the charger repaired.
Clean the light guide and
the protecting glass in the
light guide mounting hole
(please refer to "Cleaning
the Light Guide").
Clean the light guide and
the protecting glass in the
light guide mounting hole
(please refer to "Cleaning
the Light Guide").
Check to see that the
correct light guide has
been attached.
The light guide is not
designed for use with the
Elipar DeepCure-S.

Maintenance and Care

The Elipar DeepCure-S unit is maintenance-free.
No periodic maintenance is required. See the informa-
tion contained in this chapter to secure problem-free
operation.

Inserting/Removing the Battery

Never place the handpiece in the charger without the
battery inserted in the handpiece!
Use 3M ESPE batteries only! The use of other manu-
facturer batteries or non-rechargeable batteries/primary
batteries is a potential hazard and may damage the unit.
Remove the battery from the handpiece by turning
it counter-clockwise as shown by the direction of the
arrow on the underside of the handpiece.
Insert the (new) battery into the handpiece and turn it
clockwise until the seal is firmly pressed against the
metal housing.
Place the handpiece in the charger for 1.5 hours
in order to fully charge the new battery for the first
time.
- The LED showing the operating status on the
charger flashes green; see also "Operating Status
Display of the Charger".

Handpiece/Battery Care

Use only the 3M ESPE charger which is provided with
the unit; failure to do so could lead to damage to the
battery!
Do not immerse the battery in water or incinerate!
Please also observe the chapter on "Safety".

Cleaning the Light Guide

Clean and disinfect the light guide before every use.
The light guide is not sterile when delivered and
must be sterilized before being used for the first
time.
Material Resistance
Make sure that the cleaning and disinfectant agents
you have chosen do not contain any of the following
materials:
• Organic, mineral, and oxidizing acids (minimum
acceptable pH value 5.5)
• Bases (maximum acceptable pH value 8.5)
• Oxidation agents (e. g., hydrogen peroxide)
• Halogens (chlorine, iodine, bromide)
• Aromatic/halogenized hydrocarbons
Please check the manufacturer's information about the
cleaning and disinfecting agents.