Christopeit Sport Como Notice De Montage Et D'utilisation page 19

Assembly Instructions
Remove all the separate parts from the packaging, lay them
on the floor and check roughly that all are there on the base of
the assembly steps.
Please note that a number of parts are connected directly to
the main frame preassembled. In addition, there are several
other individual parts that have been attached to separate
units. This will makes assembly easier and quicker for you.
Assembly time: 30 min.
When removing the components from the carton, make sure
that the handlebar (50) turn only 90° to the right and position
into the handle holder.
Part „A" serves as a transport safety
device and it is no need after build up.
Step 1:
Attach the front stabilizer (2) to main frame (1).
1. Attach the front stabilizer (2) assembled with end caps with
transportation rollers (3) to main frame (1), using inner hex
screw M8x75 (4) and washers (5).
2. Screw in the adjustable foot (20) into appropriate position at
main frame (1) and secure the position by nut (19) to level the
item into a stabile stand.
Step 2:
Attach the seat rail (6) at main frame (1).
1. Place the connection U-plate (11) onto the seat rail (6), so that
the holes pattern and screw the connection U-plate (11) at seat
rail (6) by using screws M8x20 (12) and washers (5).
2. Lead the seat rail (6) against the main frame (1) and connect the
sensor 1 (46) with sensor connection cable (37).
3. Place the connection U-plate (11) onto the holder of main frame
(1), sothat the side holes pattern and tighten the connection U-
plate (11) at main frame (1) by using screw M10x125 (8), washer
(9) and nut (10). Don't tighten the screw (8) too much, sothat the
fold up system works easy.
4. Secure the seat rail (6) before training by screw in the hand grip-
screw (32) with washer (13) and lock up with quick release (14).
A
19