Replacing The Batteries - Ryobi ZTR480ex Traduction Des Instructions Originales

2. Make sure that the drive levers are in
the open position, and the blade engage
knob is down.
3. Set the cutting deck to the maximum
height.
1. Position the blades so that the ends point
toward the sides of the mower.
2. On the outside edge of each blade,
measure the distance from the bottom
edge of the side of the blade to the
ground. If the distance between the two
3.
4.
raise or counterclockwise to lower the
side of the cutting deck. Each full turn
NOTE: If raising the side, turn the top
bottom nut first.
5. Measure the distance between the blade
measure until the difference between the
or less.
6.
NOTE: Always level the deck side-to-side
1. Position the blade nearest the side
discharge chute so that the ends now
point toward the front and back of the
mower.
2. Measure the distance from the tip of the
blade to the ground. For best results, the
front tip of the blade should be from 0.32
than the rear tip.
3.
raise or counterclockwise to lower the
back of the cutting deck. Each full turn of
NOTE:
nuts on both sides equally to prevent
throwing the side-to-side measurement
off again.
4. Measure the distance between the blade
and ground again to verify that the front
lower than the rear tip. If not, continue to
5.
Bottom edge
Jam nut
nuts
Jam nut

REPLACING THE BATTERIES

See fig. 27 - 32.
NOTE: Use only RYOBI zero-turn mower
lead-acid batteries, part number 5131042607.
The mower operates on four 12-volt batteries
connected in series. If replacing one or more
of the batteries, always replace them using
batteries of the same type with equal voltage
and capacity.
EN
FR
DE
DA
SV
FI
NO
Blade
Fig 25
Fig 26
English | 33