Snap-on Equipment JohnBean B600P Manuel D'utilisation page 98

26
29
98
5-74
5-75
5-76
5-77
Operation
Figure 5-74 MINIMISATION "Un.10", external
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre
outer side exactly above the chuck.
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.11" is displayed (Fig. 5-76).
Figure 5-75 MINIMISATION "Un.10", internal
If the tyre cannot be turned over on the rim (e.g.:
Asymmetrical and Directional),
— press the menu key 29, then
Continue as shown on screen
—
MINIMISATION "Un.10" (Fig. 5-74).
If the tyre can be turned over on the rim;
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre, on
the inside of the wheel, exactly above the chuck.
— Turn the tyre over on the rim (tyre changer).
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.11" is displayed (Fig. 5-76).
Figure 5-76 MINIMISATION "Un.11"
— Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.12" is displayed (Fig. 5-77).