Snap-on Equipment JohnBean B600P Manuel D'utilisation page 94

26
94
20
5-64
29
5-65
5-66
5-67
5-68
Operation
5.11.3.2 WEIGHT MINIMISATION
To directly perform compensation weights Minimisation,
proceed as follows:
— Starting from the BALANCING menu press key 20
Optimisation – Minimisation (Fig. 5-64).
The OPTIMISATION screen is displayed (Fig. 5-65).
— Press key 29 (Fig. 5-65).
The MINIMISATION "Un.4" screen is displayed
5-66).
Figure 5-66 MINIMISATION "Un.4"
— Position the valve so that it is exactly perpendicular
to and above the chuck.
— Acquire the valve position by pressing the key 26.
The MINIMISATION "Un.5" screen is displayed
5-67).
Figure 5-67 MINIMISATION "Un.5"
START is signalled on the screen.
— Perform the wheel measuring run.
The MINIMISATION "Un.6" screen is displayed
5-68).
The H1 indication may appear
If H1 appears at this point, it means that the machine
recommends you do not continue with Minimisation.
Despite that, it is possible to continue, to obtain a
possible improvement in quiet running, even for values
below the threshold (critical vehicle).
(
Fig.
(
Fig.
(
Fig.