Snap-on Equipment JohnBean B600P Manuel D'utilisation page 90

26
29
26
26
90
5-57
5-58
5-59
5-60
Operation
Figure 5-57 OPTIMISATION "OP.10", external
— Rotate the wheel into marking position following the
arrows.
— In this position make a double mark on the tyre
outer side exactly above the chuck.
— Confi rm by pressing menu key 26.
The OPTIMISATION "OP.11" screen is displayed (Fig.
5-59) .
Figure 5-58 OPTIMISATION "OP.10", inside
If the tyre cannot be turned over on the rim (e.g.:
Asymmetrical and Directional),
— press the menu key 29, then
— continue as shown on screen OPTIMISATION
"OP.10" (Fig. 5-57).
If the tyre can be turned over on the rim;
— Rotate the wheel into marking position following the
arrows.
— In this position make a double mark on the inside
of the tyre, exactly above the chuck.
— Turn the tyre over on the rim (tyre changer).
— Confi rm by pressing menu key 26.
The OPTIMISATION "OP.11" screen is displayed (Fig.
5-59).
Figure 5-59 OPTIMISATION "OP.11"
— Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
— Confi rm by pressing menu key 26.
The OPTIMISATION "OP.12" screen is displayed
5-60).
(
Fig.