Maintenance; Compensation Run - Snap-on Equipment JohnBean B600P Manuel D'utilisation

3
4
104
6-1
26
6-2
1
6-3

Maintenance

6.0 Maintenance
This unit is designed to operate for a long time.
If the operator shuts down the unit correctly (
at the end of each shift, no further maintenance is
required.
This unit must not be opened by the operator, except
in accordance with explicit instructions.
6.1

Compensation Run

All clamping and centring means are balanced within
a maximum permitted tolerance.
To compensate for any residual unbalance that might
be left in the clamping tool, it is recommended that a
compensation run be performed after switching on
the machine or after changing the wheel adaptor,
especially a motorcycle wheel adaptor. This mode
cannot be transferred into the permanent memory.
Application:
— Fit the clamping device properly on the balancer
shaft. Do not fi t the wheel.
— In the MAIN MENU press key 3 three times
in succession (Fig. 6-1) and select code C 4
COMPENSATION.
The COMPENSATION screen C4 (Figure 6-2) is
displayed.
— Start the compensation run, key 4 (START).
The Compensation Run takes longer than a regular
measuring run. After the run, an icon in the Status Bar
indicates the Compensation Active status (1, Fig. 6-3).
Compensation remains active until cancelled by one
of the following cases:
- Selection of status 0 in code C 4 and confi rmation
with key 26,
- after a recalibration,
- after an optimisation run or
- by switching off the machine.
F
5.2.4)