Snap-on Equipment JohnBean B600P Manuel D'utilisation page 88

26
1
88
5-52
5-53
28 29
5-54
5-55
Operation
The OPTIMISATION "OP.9" screen is displayed
5-52).
Figure 5-52 OPTIMISATION "OP.9"
START is displayed on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The OPTIMISATION "OP.10" screen is displayed,
outside (Fig. 5-53) or the OPTIMISATION "OP.10"
screen appears, inside (Fig. 5-55).
With indication H0
Optimum condition has been achieved and cannot be
improved.
— Continue as shown on screen BALANCING (Fig.
5-62).
Indication H2
a)
Silent wheel running conditions cannot be improved.
— Press BALANCING or ESC key (1,28, Fig.5-54) to
quit Optimisation.
b)
However, it is possible to readjust the tyre with rim to
obtain a considerable reduction of weights (i.e. smaller
weights) without having an adverse effect on wheel
running noise.
— Quit the optimisation and press MINIMISATION
key in the OPTIMISATION screen page to start weight
minimisation (29, Fig.5-54)
— Continue as shown on screen OPTIMISATION
"OP.10" (Fig. 5-54).
(
Fig.