Preparation - Snap-on Equipment JohnBean B600P Manuel D'utilisation

1
46
5-9
5-10
Operation
5.4

Preparation

• The operator should be familiar with the warnings
and cautions.
• The operator should be qualifi ed to work with the
machine.
• Alwaysensure that the wheel guard is lifted and the
gauge arm is in its home position (fully retracted).
5.4.1 Power up
• Do not keep any key pressed during power up.
Refer to (Fig. 5-9).
• Insert the power cable plug in the mains socket "1".
• Set the start switch to the "I" position.
Note: If the unit beeps and does not proceed or
if an error code is shown, refer to Chapter
F
( 7).
The unit will beep and perform a self-test now.
After switch on the fi rst screen page shown is RIM
DATA ENTRY (Fig. 5-10).
The unit is now ready for commands.