Access To The Burner Unit (For Maintenance Or Repair); Instructions For Use - Dovre 425 GA Installation Et Mode D'emploi

1.5. Access to the burner unit (for maintenance or repairs)
Proceed as follows:
Open the front door and remove the ceramic blocks. You can now unscrew the (M6)
screws from the burner box.
Remove the rear heat shield. The mounting plate of the control block can now be
unscrewed.
Remove the thermal switch holder (TTB) by unscrewing the two self-tapping screws on
the back plate. Do not forget to remove the thermostat sensor from its holders.
You can now pull the complete burner unit (control block and burner) out of the back of
the appliance.
To refit the burner unit reverse the order of the steps above.

2 Instructions for use

Warning: After installation we recommend running the appliance for several hours at
the highest setting with good ventilation, to give the paint a chance of hardening. White
deposits on the glass and the interior may occur during this initial period.
This deposit can be wiped off with a dry cloth once the
appliance has cooled down.
The appliance has two burners. The rear burner is controlled by the thermostat knob. You
select the position you want and the controlling thermostat sets the correct temperature.
The front burner is controlled by the hand tap. You choose the position you want and the
burner stays in that position until you change it.
The following parts of the appliance are considered "operating surfaces" and can
therefore reach high temperatures:
• all cast iron components
• the heat exchanger
• the glass surface.
We recommend placing an additional screen around the appliance if children or older
people are present.
24 wijzigingen op grond van technische verbeteringen voorbehouden