Ignition; Thermostat Operation (Rear Burner); Using The Effects Burner (Front Burner); Extinguishing The Appliance - Dovre 425 GA Installation Et Mode D'emploi

2.1 Ignition

Open the gas valve fitted in the
gas pipe to the appliance.
• Turn the thermostat knob to
the ignition position (pilot)
and press (hold it in pressed
position).
• Press the ignition knob all the
way in until you hear a click –
this is the ignition spark.
• You can see whether the pilot
light is burning through the
glass window. If necessary click
repeatedly until the pilot light
ignites.
• When the pilot light is burning, hold the thermostat knob depressed for a further 30
seconds and then release gently.
• If the pilot light stops burning, wait five minutes and then
• repeat the procedure.
• The rear burner is ignited by turning the thermostat knob to the desired position
(position 1= low setting, position 6 = high setting).
• Turning the slider on the hand tap to the right ignites the front burner, at least if the
thermostat knob is between 1 and 6.
Warning: If the pilot light goes out, you must wait at least five minutes before re-igniting
the appliance.

2.2 Thermostat operation (rear burner)

The modulating thermostat maintains the temperature set using the thermostat knob.
If you set the thermostat, the burner will initially fire up at full power. It will then reduce
power to seek equilibrium. If the room temperature falls, the burner will increase power
until the correct temperature is restored. The
thermostat controls this automatically.

2.3 Using the effects burner (front burner)

The front burner runs at maximum power if the thermostat knob is set between position 1
and 6 and you move the slider all the way to the right. Moving the slider all the way to the
left extinguishes the effects burner.

2.4 Extinguishing the appliance

To extinguish the appliance completely, put the thermostat in the "off" position. The pilot
light will then go out. If the appliance is not to be used for a long period, it is also advisable
to close the gas cut-off valve in the inlet pipe.
wijzigingen op grond van technische verbeteringen voorbehouden
Ignition button
Thermostat
Manual control for
effects burner
25