Connecting The Ac Power Cord - Sony CDP-D500 Mode D'emploi

Connecting a fader start system
By connecting a fader start system to the REMOTE (8P)
connector on the rear panel of the player, you can fade
the sound in or out by remote control at the desired
point on a disc.
Connecting an external synchronizing system
By connecting an external synchronizing system, the
player operates on the clock frequency transmitted
from the system.
1 Connect an external synchronizing system to the
EXT SYNC connector.
2 Input the clock signal of 44.1 kHz TTL level.
3 Set EXT SYNC ON/OFF to ON.
When you don't use the external synchronizing
system, set the switch to OFF.
Setting the REMOTE SELECT switch
Set REMOTE SELECT on the front panel of the player
to activate the connector(s) for the equipment you
want to use.
REMOTE SELECT
PARALLEL SERIAL
Connector Set the switch to
RS-232C SERIAL
REMOTE (8P)
PARALLEL
Both RS-232C and
the center position
REMOTE (8P)

Connecting the AC power cord

Connect the AC power cord (supplied) to AC IN on the
rear panel and connect the other end to a wall outlet.
Getting Started
Getting Started
EN
7