Connecting The Ac Power Cord - Sony SCD-XE670 Mode D'emploi

Hooking Up the System (continued)
Connecting via ANALOG 2CH
OUT jacks
Use an audio connecting cords for this
connection. Connect the ANALOG 2CH OUT
L/R jacks to the CD (SACD) input jacks of
your amplifier. Be sure to match the color-
coded pin to the appropriate jacks: white (left)
to white and red (right) to red.
Audio connecting cords (Red and White) (not
supplied*)
White (L)
Red (R)
* If you do not make the ANALOG 5.1 CH
connection (page 6), you can use the supplied audio
connecting cable for the ANALOG 2CH
connection.
8
US
To CD (SACD) IN (L/R) jacks
White (L)
Red (R)
Connecting via DIGITAL (CD)
OUT OPTICAL connector
Use an optical digital cable for this connection.
When connecting the optical digital cable to the
DIGITAL (CD) OUT OPTICAL connector,
take the cap off the connectors and push the
cable plugs in until they click into place.
Be careful not to bend or twist the optical
cable.
Optical digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be
output from the DIGITAL (CD) OUT OPTICAL
connector. Those of the Super Audio CD cannot be
output through the DIGITAL (CD) OUT OPTICAL
connector.
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.