Sony HT-S40R Mode D'emploi page 40

[PROTECT] appears in the front
panel display of the subwoofer, the
sound is muted, and buttons on the
remote control or subwoofer other
than  (power) do not work.
 The protection feature is activated.
Press  (power) to turn the speaker
system off and disconnect the AC
power cord (mains lead) and check
the items below.
– Make sure that the ventilations of
the subwoofer are not covered and
turn on the speaker system after a
while.
– When the speaker system is using
the USB connection, remove the USB
device and turn on the speaker
system. If the speaker system
operates properly, the current of the
connected USB device is over the
maximum output current of the
speaker system 500 mA, or the USB
device may have an abnormality.
The front panel display of the
subwoofer is not lit.
 Press DIMMER to set the brightness to
[BRIGHT] or [DARK] if set to [OFF]
(page 34).
Sensors of the TV do not work
properly.
 The bar speaker may block some
sensors (such as the brightness
sensor), the remote control receiver of
your TV or the emitter for 3D glasses
(infrared transmission) of a 3D TV that
supports the infrared 3D glass system,
or wireless communication. Move the
bar speaker away from the TV within a
range that allows those parts to
operate properly. For the locations of
the sensors and remote control
receiver, refer to the operating
instructions of the TV.
Wireless function (the BLUETOOTH
function or wireless amplifier) is
unstable.
 Do not place metal objects other than
a TV around the speaker system.
40
US
The speaker system does not work
properly ([.DEMO] appears in the
front panel display).
 The speaker system is in demo mode.
To cancel demo mode, reset the
speaker system.
Press and hold  (power) and –
(volume) on the subwoofer for more
than 5 seconds (page 41).
When you change to the TV input
from the USB input by pressing
INPUT, the message appears.
Please select the desired TV channels with the TV's remote control.
HT-S40R
* This screen is an example for English.
 Select the TV program by using the TV
remote control.