Remote Control - Sony HT-S40R Mode D'emploi

Sound of the connected BLUETOOTH
mobile device is not output from the
speaker system.
 Make sure that the BLUETOOTH
indicator on the subwoofer is lit
(page 21).
 Bring the BLUETOOTH device close to
the subwoofer.
 If a device that generates
electromagnetic radiation, such as a
wireless LAN device, other
BLUETOOTH devices, or a microwave
oven is nearby, move the device away
from the speaker system.
 Move the USB 3.0 device and its cable
away from this speaker system.
 Remove any obstacle between the
speaker system and the BLUETOOTH
device or move the speaker system
away from the obstacle.
 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the connected
BLUETOOTH device.
The sound is not in sync with the
image.
 When you are watching movies, you
may hear the sound with a slight delay
from the image.

Remote Control

The remote control of this speaker
system does not function.
 Point the remote control at the
remote control sensor on the
subwoofer (page 7).
 Remove any obstacles in the path
between the remote control and the
subwoofer.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control.
TV remote control does not work.
 Install the bar speaker so that it does
not obstruct the remote control
sensor of the TV.
Others
The Control for HDMI function does
not work properly.
 Check the connection with the
speaker system (refer to the supplied
Startup Guide).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If you
unplug the speaker system, it will take
a while before operations can be
made. Wait for 15 seconds or longer,
and then try again.
 Make sure the devices connected to
the speaker system support the
Control for HDMI function.
 Enable the Control for HDMI function
of the devices connected to the
speaker system. For details, refer to
the operating instructions of your
device.
 The type and number of devices that
can be controlled by the Control for
HDMI function are restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphones): up to 1 device (used
by the speaker system)
39
US