Sony HT-S40R Mode D'emploi page 2

Masquer les pouces Voir aussi pour HT-S40R:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Owner's Record
The model and serial numbers are
located on the rear of the subwoofer.
Record the serial numbers in the space
provided below. Refer to them
whenever you call upon your Sony
dealer regarding the Home Theatre
System.
Model No. HT-S40R
Serial No.
WARNING
To reduce the risk of fire or electric
shock, do not expose this speaker
system to rain or moisture.
The speaker system is not disconnected
from the mains as long as it is connected
to the AC outlet, even if the speaker
system itself has been turned off.
To reduce the risk of fire, do not cover
the ventilation opening of the speaker
system with newspapers, tablecloths,
curtains, etc.
Do not expose the speaker system to
naked flame sources (for example,
lighted candles).
To reduce the risk of fire or electric
shock, do not expose this speaker
system to dripping or splashing, and do
not place objects filled with liquids, such
as vases, on the speaker system.
As the mains plug is used to disconnect
the speaker system from the mains,
connect the speaker system to an easily
accessible AC outlet. Should you notice
an abnormality in the speaker system,
disconnect the mains plug from the AC
outlet immediately.
Do not install the speaker system in a
confined space, such as a bookcase or
built-in cabinet.
2
US
CAUTION
Risk of explosion if the battery is
replaced by an incorrect type.
Do not expose batteries or appliances
with battery-installed to excessive heat,
such as sunshine and fire.
Do not place this product close
to medical devices.
This product (including accessories) has
magnet(s) which may interfere with
pacemakers, programmable shunt
valves for hydrocephalus treatment, or
other medical devices. Do not place this
product close to persons who use such
medical devices. Consult your doctor
before using this product if you use any
such medical device.
Indoor use only.
For the bar speaker and
surround speakers
The nameplates are located on the
bottom of the bar speaker and surround
speakers.
For customers in the U.S.A.
NOTE:
This speaker system has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This speaker
system generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this speaker system does
cause harmful interference to radio or
television reception, which can be
determined by turning the speaker
system off and on, the user is
encouraged to try to correct the

Publicité

Table des Matières
loading

Table des Matières