Technical Data - Wilo Yonos PARA High Flow Série Notice De Montage Et De Mise En Service

5.2

Technical data

Max. flow rate
Max. delivery head
speed
Mains voltage
Frequency
Rated current
Energy Efficiency Index (EEI)
Insulation class
Protection class
Power consumption P
Nominal diameters
Connection flanges
Pump weight
Permissible ambient temperature
Permissible fluid temperature
Temperature class
Max. rel. humidity
Degree of pollution
Max. permissible operating
pressure
Approved fluids
Wilo- Yonos PARA Hig Flow
Emission sound-pressure level
Residual current ΔI
Electromagnetic compatibility
1)
The pump is equipped with a power limiting function which provides protection against overload.
This can have an effect on the output depending on operation.
2)
See the following warning
Installation and operating instructions Wilo-Yonos PARA High Flow
depends on the pump type, see catalogue
depends on the pump type, see catalogue
depends on the pump type, see catalogue
1~230 V ±10% in acc. with DIN IEC 60038
50/60 Hz
see rating plate
see rating plate
see rating plate
see rating plate
see rating plate
1
see type key
see type key
depends on the pump type, see catalogue
-20°C to +40°C
-20°C to +110°C
TF110
≤ 95%
2 (IEC 60664-1)
see rating plate
Heating water (in acc. with VDI 2035/VdTÜV Tch 1466)
water/glycol mixtures, max. mixing ratio 1:1 (for mixtures with
glycol the conveying data of the pump should be corrected to
those for the higher viscosity, depending on the percentage
mixing ratio)
Only use brand-name goods with corrosion protection inhibi-
tors; comply with the manufacturer's specifications and safety
data sheets.
The pump manufacturer's approval must be obtained for the
use of other fluids.
Ethylene/propylene glycol with corrosion inhibitors.
No oxygen binders, no chemical sealants (pay attention to sys-
tem sealed with regard to corrosion technology according to VDI
2035; leaks must be reworked).
Commercially available anti-corrosion agents
without anodic inhibitors with a corrosive effect (e.g. under-
dosing due to consumption).
Commercially available combination products
without inorganic or polymer film formers
Commercially available cooling brines
< 52 dB(A) (depending on the pump type)
≤ 3.5 mA (see also section 7.2)
Emitted interference in acc. with:
EN 61800-3:2004+A1:2012 / Residential (C1)
Interference resistance in acc. with
EN 61800-3:2004+A1:2012 / Industrial (C2)
1)
1)
2)
2)
2)
English
25