Warning Signals; Spare Parts; Disposal - Wilo Yonos PARA High Flow Série Notice De Montage Et De Mise En Service

English

10.2 Warning signals

• The warning signal is indicated by the LED display (fig. 1a, item 1.1).
• The fault signal LED and the SSM relay do not respond.
• The pump continues to run with limited output.
• The indicated faulty operating status must not occur for a prolonged period. The cause
must be eliminated.
Code no. Fault
E07 Generator operation
E11 Dry running
E21 * Overload
* See also fault signal E21 (section 10.1)
Table 10.2: Warning signals
If the operating fault cannot be remedied, please consult a specialist technician or the
nearest Wilo customer service location or representative.

11 Spare parts

No spare parts are available for the Yonos PARA High Flow pumps.
In the event of damage, the entire pump should be replaced.

12 Disposal

Information on the collection of used electrical and electronic products
Proper disposal and appropriate recycling of this product prevents damage to the envi-
ronment and dangers to your personal health.
When dismantling and disposing of the pump, do not fail to observe the warnings in
Chapter 9.1!
NOTICE
Disposal in domestic waste is forbidden!
In the European Union, this symbol can appear on the product, the packaging or the
accompanying documentation. It means that the electrical and electronic products in
question must not be disposed of along with domestic waste.
To ensure proper handling, recycling and disposal of the used products in question, please
note the following points:
• Only hand over these products at designated, certified collecting points.
• Observe the locally applicable regulations!
Please consult your local municipality, the nearest waste disposal site, or the dealer who
sold the product to you for information on proper disposal. For further information on
recycling, go to www.wilo-recycling.com
Subject to technical change without prior notice
40
Cause
Pump hydraulics have fluid
running through them.
Air in the pump
Sluggish motor, pump is oper-
ated outside of its specifica-
tions (e.g. high module
temperature). The speed is
lower than during normal
operation.
Remedy
Check the system
Check the water volume/
pressure
Check the ambient conditions
WILO SE 01/2018