Network Configuration; Accessing The Web Interface On The Internet Radio; Connecting To A Power Supply; Using The Device For The First Time - Medion P66024 Notice D'utilisation

11. Network confi guration
There are two possible network configurations for the internet radio: WLAN mode
(wireless) or LAN mode (using an Ethernet cable).
• If the internet connection has been established using an Ethernet cable, select
connection type KABEL in the set-up wizard. You can manually amend all set-
tings under system settings at a later point in time.
• If you are on a wireless 802.11 a/b/g/n network, you can connect the internet ra-
dio to the internet via WLAN.
When using the device for the first time, you must select an Access Point (AP)
and enter the network key, if applicable. Thereafter the radio will always connect
to this AP automatically. If the AP can no longer be found, a message appears ac-
cordingly.

11.1. Accessing the web interface on the internet radio

When you enter the IP address of the internet radio in your browser, the
web interface of the internet radio is displayed.
You can find the current IP address under SYSTEMEINSTELLUNGEN/INTER-
•
NETEINST./EINSTELLUNGEN ANZEIGEN.
• Here, you can give your internet radio a friendly name (by default it is [MEDI-
ON]+[MAC address]).

12. Connecting to a power supply

 Connect the power supply plug on the supplied mains adapter to the ~AC IN
socket on the device.
13. Using the device for the fi rst time
When using the device for the first time, the language selection dialogue is dis-
played first.
 Select a language for the internet radio menu and press SELECT on the remote
control to confirm your selection.
A data protection notice is then displayed.
 Press SELECT on the remote control to accept the data protection provisions.
After this, the set-up wizard starts.
 Confirm the prompt EINRICHTUNGSASS. JETZT AUSFÜHREN? by press-
ing JA to start the set-up wizard.
 Select the display language for the menus and press SELECT to confirm.
The set-up wizard is displayed (in the previously set language):
If you select NEIN you can select in the next window whether the wiz-
ard is to start the next time the device is switched on.
294