Cebora MIG Manuel D'instruction page 45

Crater current may be adjusted from 10 to 200% of set welding current.
Welding starts at the torch trigger pressure.
The current called up will be the start current.
This current is maintained as long as the welding torch trigger is held down; when the welding torch trigger is released
this current connects to the welding current, which is maintained till the welding torch trigger is pressed again.
When the torch trigger is pressed again, the welding current will connect to the crater current and it will be maintained
until the torch trigger is released.
To adjust start current, connection time and crater current values, enter the main menu by pressing key F MENU
and use key PARAMETERS to enter the process parameter in the menu.
Turn knob 2 to select the parameter, press it to enter the adjustment screen and turn it to adjust the value.
Press the DEF key to restore factory settings.
D
Inductance�
0.0
Adjustment ranges from -9.9 to +9.9. Factory setting is zero. If the figure is negative, the impedance drops and the arc
becomes stiffer, while if it increases, the arc is softer.
Touch to select the function. To adjust the value, just turn knob 2.
E
Arc correction�
0.0
To modify arc length, select it by touch. To adjust the value, just turn knob 2.
F
Menu�
MENU
Touch to select this function.
Select to enter the Main Menu.
45/58