Cebora MIG Manuel D'instruction page 57

Code Type
27 [E]
30 [E]
42 [E]
45 [E]
46 [E]
47 [E]
53 [W]
54 [E]
56 [E]
57 [E]
58 [E]
61 [E]
73 [W]
74 [W]
75 [W]
76 [W]
80 [W]
84 [W]
85 [W]
98 [W]
99 [E]
Error Description
Write error in the FLASH on the
MASTER panel board
Output current sensor offset
reading problem
Motor speed out of control.
Push-pull control
recognition error
Push-pull board error
Low motor supply voltage error. Check connection between power source and wire
Start button pressed during
operating mode reset
Current not zero when power
source tested
Excessive short-circuit current
error
Excessive current on
feeder motor.
Firmware upgrade error
Incorrect mains voltage (no
phase)
Thermal protection triggered
due to excessive temperature
in secondary circuit.
Thermal protection triggered
due to excessive temperature
in primary circuit.
Coolant pressure too low.
Cooling unit not connected
Wire feeder door open
Quality control option error
Error during USB firmware
updating
Arc does not strike within the
timeout (inching timeout)
Machine is powering down.
Switch the power source on and off. If the error persists,
contact technical assistance.
Switch the power source on and off. If the error persists,
contact technical assistance.
Check there are no mechanical blockages in the wire
feeder rollers. If the motor turns at an uncontrollable
speed, check the wiring in the wire feeder and ensure
the motor feed polarity is correct. If the error persists,
contact technical assistance.
circuit Switch the power source on and off. If the error persists,
contact technical assistance.
Check that the Push Pull kit, Item No 447 is correctly
connected. Check the kit supply voltages. If the error
persists, contact technical assistance
feeder. Switch the power source on and off. If the error
persists, contact technical assistance.
Release the torch button. If the error persists, contact
technical assistance.
Switch the power source on and off. If the error persists,
contact technical assistance.
This error arises when the welder delivers a current in
excess of 15% of Imax for longer than 1.5sec. Switch the
power source on and off. If the error persists, contact
technical assistance.
wire Check there are no mechanical blockages in the wire
feeder rollers.
Switch the power source on and off. If the error persists,
contact technical assistance.
Check that the mains plug phases are properly
connected.
If the error persists, contact technical assistance.
Wait until the machine cools down. Check that the air
intake and outlet grilles are not blocked. If the problem
persists, contact technical assistance.
Wait until the machine cools down. Check that the air
intake and outlet grilles are not blocked. If the problem
persists, contact technical assistance.
Check the coolant level. Check the centrifugal pump
turns correctly. If it does not turn correctly, release
using a release screw. If the problem persists, contact
technical assistance.
Check the pressure switch connection is intact.
Check that the door of the wire feeder compartment
door is properly closed. If the problem persists, contact
technical assistance.
Check the parameters set are correct.
Make sure the USB key is correctly inserted. If the
problem persists, contact technical assistance.
Check that the "Max Inching" function is correctly set. If
the problem persists, contact technical assistance.
Wait for the power source to power down. During this
stage, do not turn the power source back on by turning
the mains switch because the power source would lock.
Turn off the machine, wait for at least 30 seconds and
turn back on.
Action
57/58