Cebora MIG Manuel D'instruction page 46

Process
SELECTING THE WELDING PROCESS, MIG, OR MMA�
After selecting the MIG
Short, and MIG Manual.
To confirm the selection press knob 2 or key
Material
SELECTING WIRE TYPE, DIAMETER AND WELDING GAS�
To confirm the selection press knob 2 or key
Parameters SELECTING PROCESS PARAMETERS
• Arc length correction.
Turn knob 2 to select the parameter and confirm the selection by pressing the same knob.
Adjust the value by turning knob 2.
To confirm the selection, press knob 2 or key
Press the DEF key to restore factory settings.
• Inductance correction.
Turn knob 2 to select the parameter and confirm the selection by pressing the knob.
Adjust the value by turning knob 2.
To confirm the selection, press knob 2 or key
Press the DEF key to restore factory settings.
46/58
welding process, with knob 2 you can select the arc transfer type: MIG Pulse, MIG
.
.
.
.