Environmental Protection - Ryobi FPR210 Manuel D'utilisation

page de 117

/ 117
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

„ Hold the cleaning accessory firmly, flush the paint

tubes thoroughly over a larger bucket.

„ Again, clean and rinse the container (not included).

„ Fill the container with cleaning solution.

NOTE: Use this bucket to clean each part of the ma-

chine as it is removed.

„ Disconnect all paint tube(s) from the machine.

To clean the paint roller:

„ Lift and remove the paint roller from the paint roller

assembly.

„ Pull the roller caps off the paint roller and clean using

cleaning solution.

„ Clean all parts in cleaning solution.

To clean the cut-in and corner pads:

„ Clean pads and all connections using a cleaning brush

(not included) and cleaning solution.

„ Fill the paint container / cleaning bucket with cleaning

solution [e.g., warm water (following the use of water

based products) or Cleaning Solvent/Paint Thinner

(following the use of oil-based products)].

To clean the tube and handle:

„ Connect Tap Adaptor to Tap by threading Clockwise

to tighten and anti-clockwise to loosen.

„ Connect Tube to bottom of Tap Adaptor by pushing

together until clicked in place and locked.

„ Connect other end of Tube to Paint Handle by pushing

together until clicked in place and locked.

„ Make sure the Flow Regulator Dial is fully open.

„ Press the Paint Handle Trigger.

NOTE: It is important to keep trigger pressed at all

times so not to allow a build up of pressure that may

damage the tubes and Paint handle.

„ Slowly turn the tap on to allow water to flow through

the system.

„ Continue to run water through tubes until they appear

clear and water exiting the end of the Paint Handle is

clean (approx 30 seconds).

„ Turn off Tap and disconnect all equipment.