Safety Warnings Specific For Wire Brushing Operations; Additional Safety Instructions; Residual Risks - Parkside Ppwsfa 20-Li A2 Traduction Des Instructions Originales

GB MT
of the workpiece on both sides of the
wheel.
• Use extra caution when mak-
ing a "pocket cut" into existing
walls or other blind areas. The
protruding wheel may cut gas or water
pipes, electrical wiring or objects that
can cause kickback.
• Do not attempt to do curved
cutting. Overstressing the wheel in-
creases the loading and susceptibility
to twisting or binding of the wheel in
the cut and the possibility of kickback
or wheel breakage, which can lead to
serious injury.
Safety Warnings Specific for Wire
Brushing Operations
• Be aware that wire bristles are
thrown by the brush even dur-
ing ordinary operation. Do not
overstress the wires by apply-
ing excessive load to the brush.
The wire bristles can easily penetrate
light clothing and/or skin.
• If the use of a guard is recom-
mended for wire brushing, do
not allow any interference of
the wire wheel or brush with
the guard. Wire wheel or brush may
expand in diameter due to work load
and centrifugal forces.

Additional safety instructions

• Never keep the fingers between the
grinding disc and spark protection or
in close proximity to the guard covers.
There is a risk of crushing.
• The rotating parts of the device cannot
be covered due to functional reasons.
Therefore, proceed cautiously and se-
cure the workpiece in order to avoid
slipping which could cause your hands
to come into contact with the grinding
disc.
42
• The workpiece becomes hot during
grinding. Do not touch the machined
area, allow it to cool down. There is a
risk of burns. Do not use coolants or the
like.
• Do not work with the device if you are
tired or have consumed alcohol or tab-
lets. Always have a break on time.
• Switch off the device and remove the
battery (22). Make sure that all moving
parts have come to a complete stop:
• to loosen a blocked insertion tool
• in case of unusual sounds
• before checking the device, clean-
ing it or performing maintenance
work on it
• Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.

Residual risks

There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Eye damage if no suitable eye protec-
tion is worn.
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of hand/arm vibration in the event that
the tool is used over a longer period
of time or is not used and maintained
properly.
• Damage to health as a result of:
• touching the area of the grinding
tool which is not covered;
• ejection of parts of workpieces or
damaged grinding discs.