To Operate The Product - Husqvarna FS 4600 G II Manuel D'utilisation

3. Push up the water pump switch (A) to engage the
water pump.
4. Push down the water pump switch (B) to disengage
the water pump.

To operate the product

1. Make sure that the lever speed control is in the stop
position.
WARNING:
damage or injury if the lever for speed
control is in a forward or rearward
position.
2. Start the engine. Refer to
page 19 .
1657 - 001 - 08.09.2021
A
B
There is a risk of
To start the product on
3. If the water pump is not installed on the product,
open the water valve and adjust the water flow.
4. If the water pump is installed on the product, do the
procedure that follows.
a) Push up the water pump switch to engage the
water pump. Refer to
on page 20 .
b) Open the water valve.
c) Adjust the water flow with the water tap.
To operate the water pump
21