Husqvarna FS 4600 G II Manuel D'utilisation page 44

• Always use approved containers for transportation of
fuel.
• Examine new cutting blades for transport damage.
To move the product with the engine on
1. Put the lever for speed control into the stop position.
2. Remove the cutting blade. Refer to
cutting blade on page 17 .
3. Start the engine without connect the water to the
To start the product on page 19 .
product. Refer to
4. Push or tap the throttle control switch to correct
engine speed.
44
5. Push the lever for speed control forward for forward
To move the product up and down a ramp
To remove the
•
•
To move the product with the engine off
saw movement, or rearward for reverse movement.
The more you push the lever for speed control, the
more the speed increases. Refer to
on page 48 .
WARNING:
move the product up and down ramps with
the engine on. The product is heavy and
there is a risk of injury if the product falls or
moves too quickly.
WARNING:
angle, always use a winch. Do not walk or
stay below the product.
WARNING:
rearward and cause injury or damage. Be
careful when you tilt the product rearward or
lift the product.
WARNING:
down a ramp in freewheel position. Always
move the product forward down ramps and
slopes. Do not walk beside or stay below the
ramp when you move the product down a
ramp.
To move the product down a ramp, operate the
product forward slowly.
To move the product up a ramp, operate the product
rearward slowly.
WARNING:
product when the freewheel function is
engaged. The product can move away from
you and cause injury to bystanders.
Technical data
Be very careful when you
For ramps with a large
The product can easily tilt
Do not move the product
Maintain control of the
1657 - 001 - 08.09.2021