Husqvarna FS 4600 G II Manuel D'utilisation page 34

7. Open the oil tank cap and fill the system with engine
Technical data on page 48 .
oil. Refer to
To replace the oil filter for the hydraulic
propulsion system
1. Remove the oil filter and discard it.
2. Fill a new oil filter with oil. Refer to
page 48 for the correct type of oil.
3. Lubricate the seal with some drops of oil.
4. Install the oil filter.
5. Make sure that the product is level.
34
6. Remove the hydraulic reservoir cap and fill with new
7. Install the hydraulic reservoir cap.
To do a check of the drive belts
1. Loosen the 2 bolts (A) from the protective cover on
Technical data on
2. Remove the bolt, the washer and the nut (B) from
3. Remove the protective cover (C).
4. If you examine the tension of the drive belts with a
5. If you examine the tension of the drive belts without
oil to the correct oil level. Refer to
the oil level for the hydraulic propulsion system on
page 37 .
the left side of the product.
A
the protective cover.
frequency test, do the procedure that follows.
a) Do a check of the frequency of the drive belts.
The tension of a new drive belts is correct when
the drive belts frequency is 110 Hz. The tension
of a used drive belt is correct when the drive belt
frequency is 95–110 Hz.
a frequency test, do the procedure that follows.
To do a check of
C
B
1657 - 001 - 08.09.2021