Husqvarna FS 4600 G II Manuel D'utilisation page 11

Machine stop button
The machine stop button quickly stops the engine. The
machine stop button does not stop the lights and the
function to lift or lower the cutting blade. The machine
stop button sets the product in safe mode. The product
cannot start again until the safe mode is reset.
Note:
Do not use the machine stop button to stop the
product unless there is an emergency. For correct
procedure how to stop the product during operation,
To stop the product on page 25 .
refer to
To do a check of the machine stop button
1. Start the engine. Refer to
page 19 .
2. Push the machine stop button. The engine stops and
the product is set to safe mode.
3. Turn the machine stop button counterclockwise to
disengage the machine stop.
Blade guard
The blade guard is a protective cover for the top part of
the cutting blade. It gives protection if parts from a
damaged cutting blade or other objects eject in the
direction of the operator. The blade guard prevents
injury from the cutting blade. The blade guard is also a
part of the water cooling system that keeps the cutting
blade cool during operation.
1657 - 001 - 08.09.2021
To start the product on
To do a check of the blade guard
• Make sure that the blade guard is correctly installed.
To install a blade guard on page 17 .
Refer to
• Examine the blade guard for damages, such as
cracks.
• Replace a damaged blade guard.
• Replace the blade guard if it is hit, bent or has other
defects.
• Examine the wire and the carabiner for damages.
• Make sure that the carabiner is correctly attached.
Protective covers
Missing or damaged protective covers increase the risk
of injury on moving parts and hot surfaces.
To do a check of the protective covers
• Do a check of the protective covers before you
operate the product.
• Make sure that the protective covers are correctly
attached and do not have cracks or other damages.
• Replace damaged protective covers.
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
11