Husqvarna FS 4600 G II Manuel D'utilisation page 26

2. Push down and hold the throttle control switch until
the engine operate at idle speed.
3. If the water pump is in operation, push down the
water pump switch to disengage the water pump.
To operate the water pump on page 20 .
Refer to
4. Close the water valve.
5. Let the engine operate at idle speed for 2-3 minutes.
6. Turn the ignition key to the "0" position to stop the
engine.
26
WARNING:
continues to rotate for a while after the
engine stops. Do not stop the cutting
blade with your hands. Serious injuries
can occur.
7. When the cutting blade stops, push the lever for the
cutting depth adjustment forward to lower the cutting
blade.
8. Make sure that the knob for rear axle freewheel
function (A) is disengaged.
A
The cutting blade
1657 - 001 - 08.09.2021