Husqvarna FS 4600 G II Manuel D'utilisation page 37

a) If the tension of the engine belt is too low, loosen
the bolt for the alternator and push the alternator
more forward.
b) Do this procedure again until the engine belt
tension is correct.
CAUTION:
tension of the engine belt too much.
To examine the wheels
• Examine the wheels for wear or damage. Replace
wheels and hubs if they are damaged or worn out.
• Examine if the rear wheel hubs and wheels are
loose. Tighten loose screws and nuts.
To do a check of the oil level for the
hydraulic propulsion system
1. Remove the hydraulic reservoir cap.
2. Clean the oil from the dipstick below the hydraulic
reservoir cap.
3. Put the dipstick fully into the hydraulic reservoir.
4. Remove the dipstick.
1657 - 001 - 08.09.2021
Do not adjust the
5. Examine the oil level on the dipstick. Make sure that
the level of oil is between the marks on the dipstick.
6. If the oil level is low, fill with oil and do a check of the
oil level again. Refer to
for correct oil type.
7. Install the hydraulic reservoir cap.
To replace the hydraulic propulsion
system oil
1. Remove the hydraulic reservoir cap.
2. Use a manual oil pump to drain the oil through the
hydraulic reservoir cap opening on the hydraulic
reservoir.
3. Replace the oil filter. Refer to
for the hydraulic propulsion system on page 34 .
Technical data on page 48
To replace the oil filter
37