Husqvarna FS 4600 G II Manuel D'utilisation page 38

To replace the oil of the hydraulic lift
pump
1. Turn the 2 rear hatch latches (A) and remove the
rear hatch (B).
2. Remove the oil filler cap.
3. Drain the oil of the hydraulic lift pump with a manual
oil pump.
4. Fill with new oil. For the correct type of oil, refer to
Technical data on page 48 .
5. Do a check of the oil level in the hydraulic lift pump.
To do a check of the oil level for the
Refer to
hydraulic lift pump on page 31 .
6. Tighten the oil filler cap.
7. Install the rear hatch and turn the 2 rear hatch
latches.
38
A
B
To lubricate the product
1. Clean the 7 grease nipples (A).
A
2. Replace broken or blocked grease nipples.
3. Lubricate the front wheels.
4. Lubricate the pivot bearings of the front axle.
5. Lubricate the pivot pin on the hydraulic cylinder.
6. Lubricate the rear axle bearings.
For more information about lubrication, refer to
Technical data on page 48 .
To replace the oil in the gearbox
1. Put a container (A) below the gearbox.
B
A
1657 - 001 - 08.09.2021