To Stop The Product; Maintenance Schedule; Maintenance - Husqvarna K 770 Vac Manuel D'utilisation

WARNING: Do not wind the starter rope
around your hand.
7. Pull the starter rope slowly until you feel a resistance
as the starter pawls engage. Then pull continuously
and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.

To stop the product

WARNING: The cutting blade continues to
rotate up to a minute after the motor stops
(known as blade coasting). Make sure that
the cutting blade can rotate freely until it
completely stops. Carelessness can cause
serious personal injury.

Maintenance schedule

The maintenance schedule shows the neccessary
maintenance of the product. The intervals are calculated
on daily use of the product.
Daily
Clean External cleaning
Cold air intake
Replace
Function inspec- General inspection
tion
Throttle lockout*
Stop switch*
Blade guard, blade guard
extender and dust shield*
Cutting blade*
Safety devices on the product on page 6 .
* Refer to
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
705 - 002 - 12.11.2018
• Move the STOP switch to the right to stop the
engine.

Maintenance

Weekly
Vibration damping sys-
tem*
Muffler*
Drive belt
Carburetor
Starter housing
To clean the cold air intake
Note: A dirty or blocked air intake makes the product too
hot. This can cause damage to the piston and cylinder.
Monthly
Spark plug
Fuel tank
Fuel system
Air filter
Clutch
Yearly
Fuel filter
21