Erogazione Caffè; Coffee Dispensing; Distribution Café - Victoria Arduino Eagle One Manuel D'instructions

Masquer les pouces Voir aussi pour Eagle One:
Table des Matières

Publicité

IT
6.2
EROGAZIONE CAFFÈ
Dopo aver messo a punto la macchina:
Inserire il filtro desiderato (singolo o
doppio all'interno del portafiltro).
Riempire il filtro con caffè opportuna-
mente macinato.
Pressare il caffè nel filtro in maniera
uniforme con l'apposito pressino.
Pulire dai residui di polvere di caffè il
bordo anulare del filtro.
Prima di inserire il portafiltro nel
gruppo, è necessario spurgare per al-
meno 2 secondi l'acqua presente nel
circuito del gruppo attivando e disat-
tivando l'erogazione.
Inserire il portafiltro nel gruppo ero-
gazione.
Posizionare la/le tazzina/e sotto i bec-
cucci e premere il pulsante caffè de-
siderato.
Al termine di ogni erogazione di caffè
lasciare il portafiltro innestato al grup-
po affinché rimanga sempre caldo.
38
EN
6.2

COFFEE DISPENSING

After commissioning the machine:
Insert the desired filter (single or dou-
ble inside the filter holder).
Fill the filter with coffee appropriately
ground.
Press the coffee in the filter uniformly
using the appropriate presser.
Clean the edge of the filter of coffee
residues and insert the filter holder
into the dispensing unit.
Before insert the filter holder, the group
must be purged for at least 2 seconds
to refresh the water present in the cir-
cuit, turning on and off the supply.
Insert the filter holder inside the dis-
pensing group.
Position the cup/s under the spout/s
and press the desired coffee button.
At the end of each coffee dispensing
leave the filter-holder inserted in the
unit so that it will keep warm.
FR
6.2
DISTRIBUTION CAFÉ
Après avoir mis au point la machine:
Introduire le filtre désiré (simple ou
double à l'intérieur du porte-filtre).
Remplir le filtre de café moulu.
Presser le café uniformément dans le
filtre à l'aide du presseur.
Nettoyer le bord du filtre pour enlever
tout résidu de café en poudre.
Avant d'insérer le porte-filtre dans le
groupe, il est nécessaire de purger
l'eau dans le circuit du groupe pen-
dant au moins 2 secondes, en acti-
vant et désactivant la distribution.
Introduire le porte-filtre dans le
groupe de distribution.
Placer la ou les tasses sous les becs et
appuyer sur la touche café souhaitée.
À la fin de chaque distribution de café,
laisser le porte-filtre attaché à l'appareil
pour qu'il reste chaud en permanence.

Publicité

Table des Matières
loading

Table des Matières