Victoria Arduino Eagle One Manuel D'instructions page 11

Masquer les pouces Voir aussi pour Eagle One:
Table des Matières

Publicité

pires if the characteristics of the power supply do not correspond to the nameplate data.
When installing the device, it is necessary to use the parts and materials supplied with the device
itself. Should it be necessary to use other parts, the installation engineer needs to check their suit-
ability for use in contact with water for human consumption. The installer must Make the hydraulic
connections respecting the rules of hygiene and water safety to environmental protection in force
in the place of installation. So for the hydraulic plant contact an authorized technician. Always utilise
the new hose supplied for connection to the water supply. Old hoses must not be utilised.
It is advisable the installation of a residual current device (RCD) having a rated residual operating
current not exceeding 30 mA.
The appliance must be permanently connected to the power mains via a disconnect device having
a contact separating mechanism in all poles that provide the total disconnection in the overvoltage
category III and that must be installed in the power supply system as per wiring standards.
For Australian and New Zealand markets the disconnection switch must be installed according to
AS/NZS 3000 standard.
There are some basic rules for the use of any electrical appliance. In particular:
Never touch the unit with wet hands or feet;
Never use the unit with bare feet;
Never use extension cords in areas equipped with baths or showers;
Never pull on the power supply cord to unplug the unit;
Never leave the unit exposed to atmospheric agents (rain, direct sunlight, etc..);
Never let children, unauthorized personnel or anyone who has not read this manual operate the
unit.
The qualified electrician must also check that the section of the installation's cables is large enough
for the absorbed power of the appliance.
Never use adapters, multiple jacks or extension cords. When such items prove absolutely necessary,
call in a qualified electrician.
To prevent dangerous overheating, it is advisable to fully extend the power supply cord. Never block
the intake and/or heat dissipation grills, in particular those for the cup warmer.
The user must never replace the unit's power supply cord. If this cord is damaged, turn off the unit
and have it replaced by a professionally qualified technician.
In case of installation in kitchens, connect the equipotential conductor to
the terminal in the machine bottom indicated by the symbol
The manufacturer cannot be held responsible for any damages incurred if
the system is not grounded.
For electrical safety, this machine requires a ground system. Contact a tech-
nically certified electrician who must check that the line electrical capacity
is adequate for the maximum capacity indicated on the unit label.
.
11

Publicité

Table des Matières
loading

Table des Matières