Victoria Arduino Eagle One Manuel D'instructions page 12

Masquer les pouces Voir aussi pour Eagle One:
Table des Matières

Publicité

Should it be necessary to replace the power cord, this replacement operation must only be per-
formed by an authorized service centre or by the manufacturer.
The device needs to be supplied with water that is suitable for human consumption and compliant
with the regulations in force in the place of installation. The installation engineer needs confirmation
from the owner/manager of the system that the water complies with the requirements and stand-
ards stated above.
For machines connected to the mains water supply, the minimum pressure must be 0.2 MPa (2 bar)
and the maximum pressure for correct machine operation must not exceed 0.65 MPa (6,5 bar).
The operating temperature must be within the range of [+5, +25]°C. In case of prolonged storage at a
temperature below 2 °C, empty the machine hydraulic system to prevent it from freezing. In case of
freezing, do not switch the machine on before having reconditioned it for at least 1 hour at a suitable
room temperature.
At the end of installation, the device is switched on and taken to rated operating conditions, leaving
it in a state in which it is "ready for operation".
After reaching the "ready for operation" condition, the following dispensing operations are carried
out:
100% of the coffee circuit through the coffee dispenser (for more than one dispenser, this is divided
equally);
100% of the hot water circuit through the water dispenser (for several dispensers it is divided equal-
ly).
Open the steam outlet for 1 minute.
At the end of installation, it is good practice to draw up a report of the operations.
It is forbidden to leave the machine switched on without the presence and surveillance of a qualified
operator. Simonelli Group is not responsible for damages caused by failure to comply with this pro-
hibition.
Be extremely careful when using the steam nozzle. Never place your hands under the nozzle and
never touch it right after use.
Before cleaning the unit, follow the instructions given in this manual at chapter 9 carefully.
Once started the washing machine, do not interrupt, the detergent residue may remain inside the
delivery unit.
In case of breakdown or poor function, turn off the unit. Never tamper with the unit. Contact only
professionally qualified personnel. Only the manufacturer or an authorized service center can make
repairs and only using original spare parts. Non compliance with the above can compromise ma-
chine safety.
In case of fire, disconnect power to the machine by turning off the main switch. Its absolutely avoid
to extinguish the fire with water while power to the machine is on.
Before performing any sort of maintenance, the authorized technician must turn off the unit and
unplug it from the mains.
12

Publicité

Table des Matières
loading

Table des Matières